#ALLEN DATAGRAPH 536 OLD MODEL DRIVER#
com1 10) Click Have Disk 11) Click Browse 12) Navigate to C:\Program Files\Allen Datagraph\Cutter Driver 13) Click Open 14) Click OK 15) Select model number of cutter 16) Click Next 17) Select “replace existing driver” to upgrade to new version. If cutter is attached to com1 the name of the port should be COM1.DOS 9) Select com port cutter is attached. 6) Click Next 7) Select Create a new port (Local Port) 8) Type in COMx.DOS as the name of the port. 3) Click on add a printer 4) Click Next 5) Select Local Printer attached to this computer. 2) Select start, control panel, printers and faxes. Reboot your computer, and then proceed with the installation of the new driver. Driver Installation instructions Note: If you already have an older version of the Allen driver installed and you are upgrading to a new version, delete the old driver before installing the newer one. Tested with: CorelDRAW, Adobe Illustrator, SignLab, Flexi Sign, Gerber Omega, AutoCAD 2002, PowerCad. The sprocket material-handling system is the Monument Industry's preferred cutting solution for processing sandblast stencil material.
#ALLEN DATAGRAPH 536 OLD MODEL WINDOWS#
26Īllen Datagraph 230/315 Vinyl Cutter WINDOWS XP / WINDOWS 2000 DRIVER Note: This driver requires Windows 2000 or Windows XP to operate. Allen Datagraph 536GTS Stencil Cutter Only Hyatt's best selling Stencil Cutter The innovative Allen Datagraph 536GTS has both sprocket and friction drives. This value can be saved in the programmable Set- Ups. The higher the value, the less accurate but faster cutting will be. The lower the value, the more accurate but slower cutting will be. If the angle is at or above the minimum angle, then compensation at the current offset value is performed. If this angle is below the minimum angle, no rotation is performed. The Minimum Angle between vectors at which knife offset compensation (rotation) is performed. The acceleration range may be set from 01 to 16 via the SETTINGS menu. The maximum recommended acceleration rate for rolls is 08 because greater rates tend to cause material slippage and tracking problems on roll material.
High acceleration will produce faster cutting when a graphic image has many short vectors (line segments). Acceleration is the rate at which a given speed is achieved. From the front panel speed control knob, the up speed will be equal to the down speed. The up speed range may be set from 1 to 60 cm/sec (1 to 100%). The Up Speed is the speed of the tool movement when the tool is in the up position. The down speed range may be set from 1 to 60 cm/sec(1to 100%). Prices are subject to change from the manufacturer. Does not include sales tax, setup, training or shipping and handling. Down Speed Up Speed Acceleration Minimum Angle The Down Speed (cut speed) is movement when the tool is in the down position. The Model 536 delivers precision, reliability and high performancewhatever the application.
The values of these parameters are determined in the Set- Ups and have been optimized for the various tool and material combinations. Allen Datagraph 230/315 Vinyl Cutter Cutter Performance The 230/315 Vinyl Cutter's performance is controlled by many parameters including Force, Up Speed, Down Speed, Load Speed, Acceleration and Offset.
0 kommentar(er)
